Ricoh Aficio GX7000 - Manual (Page 209)

Error & Status Messages on the Control Panel
This section explains what the messages that appear on the control panel mean and what to do when a
particular message appears.
Depending on the “Auto Continue” and “Env.Slctr.Alert” settings specified on the System menu, some of
the following messages might not appear.
• See p.147 "Specifying System Settings using the Control Panel (System Menu)"
Control Panel Error Messages
Hardware Problem Ethernet Board
An error in the network interface board (ethernet board) network function has occurred.
See p.238 "Network Interface Board Error".
Ink Collector is not set / Set the Ink Collector Unit
The ink collector unit has not been installed correctly. Reset the ink collector unit correctly.
See p.236 "Ink Collector Unit Not Detected".
Ink Collector Unit is full / Replace Ink Collector Unit
The ink collector unit is full. Replace the ink collector unit.
See p.258 "Where to Inquire".
Ink Collector almost full
The ink collector unit is almost full. Make sure you have a new ink collector on hand.
See p.258 "Where to Inquire".
Low Ink
The ink runs out. Change the print cartridge.
See p.154 "Replacing a Print Cartridge".
Open Front Cover / Replace Ink Crtg
The ink in the indicated print cartridge has run out. Change the indicated print cartridge.
See p.154 "Replacing a Print Cartridge".
Paper Misfeed / Press Form Feed
The printer failed to feed paper from the specified paper tray. Press the [Form Feed / Head-cleaning] key
to feed the paper.
See p.178 "Using the [Form Feed / Head-cleaning] Key to Remove Jammed Paper".
Error & Status Messages on the Control Panel
207
6