Roland V-Synth - Manual (Page 91)

91
Connecting to Your Computer via USB (USB Mode)
Connecting to Your Computer via USB (USB Mode)
6. Touch .
7. If a WARNING window like the following appears, touch
to close the window.
fig.07-01_50
8. In the lower right of the SYSTEM Com MIDI/USB screen,
touch to save the system settings.
Windows Users
● Windows 98/98SE Users
You must install the driver from the included CD-ROM into your
computer. Be sure to read the Readme file on the CD-ROM before
installation.
→
\Storage\Wn98\Readme_e.htm
● Windows XP/2000/Me or later Users
Installation is completely automatic.
Connecting the V-Synth to Your
Computer
1. Make sure that the power of the V-Synth is turned off.
2. Start up your computer.
3. Connect the V-Synth and your computer using a USB cable.
fig.07-02.e
4. Turn on the power of V-Synth.
5. If you are using a PC card, insert that PC card into the PC
CARD slot.
6. Press [MODE] to access the V-SYNTH MODE MENU window.
7. Touch .
The USB Storage screen appears.
fig.07-03_50
If the USB Mode (p. 76) is set to “MIDI,” you will be unable to
select in the V-SYNTH MODE MENU window. Set the
USB Mode to “Storage.”
For the rest of the procedure, read either “Windows Me/2000/
XP users” or “Macintosh users” as appropriate.
Windows users: Continue reading from this page.
Macintosh users: Read from page 93.
USB Connector
USB cable
USB
V-Synth
Computer