Roland V-Synth - Manual (Page 138)

138
Effects List
Chorus Parameters
The functions of Chorus parameters are explained.
Chorus Type
01: Chorus 1
This conventional chorus effect adds spaciousness and depth to the
sound. Slow modulation frequency with less depth.
02:Chorus 2
This conventional chorus effect adds spaciousness and depth to the
sound. Rapid modulation frequency with less depth.
03: Chorus 3
This conventional chorus effect adds spaciousness and depth to the
sound. Slow modulation frequency with more depth.
04: Chorus 4
This conventional chorus effect adds spaciousness and depth to the
sound. Rapid modulation frequency with more depth.
05: Feedback Chorus
This chorus offers a flanger-like effect, creating a soft sound.
06: Flanger
This effect sounds somewhat like a jet airplane taking off and
landing.
07: Short Delay
This is a delay with a short delay time.
08: Fbk Short Delay
This is a short delay with many repeats.
Chorus Parameters
Reverb Parameters
The functions of Reverb parameters are explained.
Explanations for each Reverb Type are given on the following
pages.
01: Room 1 (p. 139)
02: Room 2 (p. 139)
03: Room 3 (p. 140)
04: Hall 1 (p. 140)
05: Hall 2 (p. 141)
06: Hall 3 (p. 141)
07: Garage (p. 142)
08: Plate (p. 142)
09: Non-Linear (p. 143)
10: Delay (p. 143)
Parameter Value Description
Pre Low Freq 500–15000 Hz,
THRU Frequency of the low range
(THRU: no filter is used)
Pre Hi Freq THRU, 50–800 Hz Frequency of the high
range (THRU: no filter is
used)
Pre Dly Time 0–50.0 ms Adjusts the delay time from
the direct sound until the
chorus sound is heard.
Co LPF Freq 500–15000 Hz,
THRU Adjusts the cutoff frequen-
cy of the low pass filter.
(THRU: no filter is used)
The effect will be applied to
the frequency range below
the cutoff frequency.
Co HPF Freq THRU, 50–800 Hz Adjusts the cutoff frequen-
cy of the high pass filter.
(THRU: no filter is used)
The effect will be applied to
the frequency range above
the cutoff frequency.
Rate 0.05–10.0 Hz, note Sets the cycle for the chorus
or flanger sound undula-
tions.
Depth 0–127 Adjusts the depth of modu-
lation for the chorus or
flanger.
Feedback -98– +98 % Adjusts the proportion of
the effect sound that is fed
back into the effect. Nega-
tive (-) settings will invert
the phase.
Cho/Flg Sw CHORUS,
FLANGER Selects either chorus or
flanger.