Roland V-Synth - Manual (Page 34)

34
Creating a Patch
Naming a Patch (PATCH
Name)
Before you save the patch, here’s how to give it a new name.
1. Make sure that the patch that you want to name is selected.
2. Touch < ▼ > in the upper right of the screen.
A pulldown menu appears.
fig.03-02a_50
3. In the pulldown menu, touch .
The PATCH Name window appears.
fig.03-03_50
4. Touch the on-screen alphabetic or numeric keys to enter the
new name in the text box.
The on-screen keys have the following functions.
<
←
><
→
>: Move the cursor in the text box to the desired input
location.
: Turn this on when you want to input uppercase letters
or symbols.
: Turn this on when you want to insert a character at the
cursor location.
: Erases all characters in the text box.
: Deletes the character at the cursor location.
: Deletes the character that precedes the cursor location.
You can also move the input location cursor by pressing the
[
][ ] cursor buttons. Pressing [ ] will change the
character at the cursor location to uppercase, and pressing [ ]
will change it to lowercase.
5. When you have finished inputting, touch to finalize the
patch name.
Saving Patches (PATCH Write)
Changes you make to sound settings are temporary, and will be lost
if you turn off the power or select another sound. If you want to keep
the modified sound, you must save it in the internal (internal
memory).
When you modify the settings of a patch, the PATCH PLAY screen
will indicate “EDITED.” Once you save the patch into internal
memory, the “EDITED” indication goes away.
When you perform the save procedure, the data that previously
occupied the save destination will be lost. However, the factory
setting data can be recovered by performing the Factory Reset
(p. 98).
1. Make sure that the patch you wish to save is selected.
2. Touch < ▼ > in the upper right of the screen.
A pulldown menu appears.
fig.03-03a_50
3. In the pulldown menu, touch .
The PATCH Write window appears.
fig.03-04_50
4. Turn the VALUE dial to specify the save-destination patch.