Ricoh RDC-7 - Manual (Page 70)

68
28
INTERVAL MODE
START:RELEASE INTERVAL MODE
START:RELEASE
CANCEL:CANCEL CANCEL:CANCEL
t
Press the ENTER button again after
setting the digit for the seconds.
The interval timer is now enabled.
Note
• The interval shooting mode is
canceled when you set the mode
dial to another mode or turn the
camera off while the “INTERVAL”
message is lit on the LCD monitor.
y
Press the shutter release button.
The camera will take the first shot and then
proceed to shoot at the preset interval.
The “INTERVAL” message flashes on the
LCD monitor while interval shooting is in
progress. Shooting will continue until the
internal memory or SmartMedia memory card
runs out of available memory.
Note
• You can take normal shots by pressing the shutter button while interval
shooting is in progress. The preset interval will not be affected.
• The actual interval between shots may be longer than the preset time
depending on the image quality and flash mode settings.
• If the camera is powered by the battery, it is possible for the battery
may run out during interval shooting. It is therefore recommended to
use an AC adapter (optional) for interval shooting.
Auto Bracket Shooting
Auto bracket shooting allows you to take 3 frames in succession at exposure
compensation values of –0.5 EV, 0 and +0.5 EV, based on the exposure
compensation value set in “Setting the Exposure Compensation” (p.56).
To prevent camera shake, mount the camera on a tripod or set it on a flat
surface when taking the pictures.
q
Set the mode dial to [ ] and press
the MENU button.