Ricoh RDC-7 - Manual (Page 49)

47
Shooting
2
ERASE THIS IMAGE?
START:RELEASE
CANCEL:CANCEL
● Flash LED
The flash LED (red) lights when you press
the shutter button lightly in low light
conditions.
Note
• The flash LED (red) blinks and the
LCD monitor is cleared while the
flash is charging. Pictures cannot be
taken in this state.
r
Press the shutter release button
down fully without removing your
finger.
A beep will sound and the picture you have
taken appears on the LCD monitor before it
is recorded.
Note • Moving the camera before the beep sounds may result in a blurred
image.
• You can incorporate sound into your recording. See “Still Picture/Text
Shooting with Sound”
→
(p.52).
How to Cancel Recording
When you press down the shutter button
fully, the shot image will appear on the
LCD monitor. To cancel recording, press
the
button, and then press the shutter
button when the cancel confirmation
message is displayed.
You can change the image confirmation time as desired. See “Changing LCD
Confirmation Time”
→
(p.100).
Important
Note
• Do not open the battery cover or card door or detach the AC adapter
during recording.
• The AF LED and Recording destination ( • ) will blink while the
image is being recorded. Do not rotate the mode dial or turn off the
power until recording has been completed.
It is not possible to use the / button or use the MENU button to
display the menu screen while an image is being recorded.