Ricoh RDC-7 - Manual (Page 104)

102
File Numbering System
When recording onto a SmartMedia memory card, you can choose whether the
shot files will automatically be assigned consecutive numbers.
● When [SEQUENTIAL NO.] is [ON]
Numbers from R0010001 to R9999999 will be assigned to files.
As the camera saves the last number that was assigned, even when a new
SmartMedia card is inserted, the subsequent number is assigned to the next
image that is shot.
However, if the SmartMedia memory card contains a number that is bigger than
the number saved by the camera, the next number after the one on the
SmartMedia memory card will be assigned.
* Consecutive numbers will be assigned to files even if a different SmartMedia memory
card is inserted. No file numbers will be duplicated.
* In some cases, file numbers on the same SmartMedia memory card may not be in
consecutive order.
* To reset the numbering system, follow the procedures in “Initializing Settings” (p.104)
and insert a SmartMedia memory card on which there are no images.
● When [SEQUENTIAL NO.] is [OFF]
Numbers from RIMG0001 to RIMG9999 will be assigned to files.
When a new SmartMedia memory card is inserted, numbering starts in
sequence from RIMG0001. When a SmartMedia card on which files have been
recorded is inserted, the next file is assigned the next number on the
SmartMedia memory card.
* Numbering starts from RIMG0001 on each SmartMedia memory card.
* When the number RIMG9999 is reached, the [FILE NUMBER OVER] message is
displayed and no more files can be recorded. See “Warning Messages”
→
(p.8).
Note
• Numbering starts from RIMG0001 when the internal memory is
selected as the recording destination.
• Using the consecutive numbering system (when [SEQUENTIAL NO.]
is [ON]) is useful when submitting images to digital printing services or
keeping files on a PC as there is no risk of the same number being
assigned twice.
q
Set the mode dial to [ ].
w
Press the or button to select
[SEQUENTIAL NO.].
e
Press the or button to select
[ON] or [OFF] and press the ENTER
button.
If you select [OFF], files will be assigned
numbers starting from RIMG0001.
BEEP SOUND ON
SET 2/3
POWER SAVE MODE OFF
DATE SETTING 2000/ 6/15
VIDEO OUT MODE NTSC
SELECT: CHANGE:
SEL.:ENTER
SEQUENTIAL NO. OFF