Ricoh RDC-7 - Manual (Page 36)

34
BEEP SOUND ON
SET 2/3
POWER SAVE MODE OFF
DATE SETTING 2000/ 6/15
VIDEO OUT MODE NTSC
SELECT: CHANGE:
SEL.:ENTER
SEQUENTIAL NO. OFF
2000/ 1/ 1
SELECT:
BACK:CANCEL SEL.:ENTER
DATE SETTING
Setting the Date and Time
The set date and time are recorded when you shoot a picture. You will need to
adjust these settings when you first use the camera and each time you change
time zones on trips.
Note • Use the yyyy/mm/dd format to set the date.
• Time is displayed in the 24-hour clock format. Midnight is expressed
as 00:00 and noon as 12:00.
q
Press the power switch to turn the
camera on and set the mode dial to
[
].
See
“Turning on the Camera” (p.41).
w
Press the or button to select
[DATE SETTING].
e
Press the DISPLAY button to select
the date display method.
There are three ways of displaying the date:
2000/5/15 ➞ May 15 2000 ➞ 15 May 2000
Each time you press the DISPLAY button, the
display method is switched in the sequence
shown above. Press the DISPLAY button to
select the desired date display method.
r
Press the ENTER button.
The date setting menu is displayed.
t
Press the or button to change
the flashing digit.
Press the button to increase the digit and
the button to decrease the digit. Pressing
the button continuously increases the speed.