Roland XV-3080 - Manual (Page 78)

78
Chapter 3 Selecting Output Jacks
Rhythm Set Mode Settings
Signal(RHYTHM TONE) Flow
fig.3-03
Parameters
The parameters related to Rhythm Set output settings are
shown below.
A0–C8 OUTPUT ([RHYTHM]-[EFFECTS])
This sets the output destination and level for each Rhythm
Tone, as well as the Tone’s send level to the Chorus and
Reverb.
Output Assign
MFX: The Rhythm Tone is sent into the Multi-Effects. Its final
output destination is determined according by the Multi-
Effects output setting.
OUTPUT A–C: The Rhythm Tone is sent to the selected
OUTPUT A–C jacks.
INDIVIDUAL 1–6: The Rhythm Tone is sent to the selected
INDIVIDUAL 1–6 jack.
Chorus (Chorus Send Level) 0–127
This sets the Rhythm Tone’s send level into the Chorus. Its
final output destination is determined by the Chorus output
setting.
Reverb (Reverb Send Level) 0–127
This sets the Rhythm Tone’s send level into the Reverb. Its
final output destination is determined by the Reverb output
setting.
RHYTHM COMMON ([RHYTHM]-
[COMMON])
Level (Rhythm level)0–127
This sets the volume of the entire Rhythm Set.
Output Assign
This specifies the output destination of the entire Rhythm
Set.
MFX: This sends all of the Rhythm Set’s Rhythm Tones into
the Multi-Effects. Their final output destination is
determined by the Multi-Effects output setting.
OUTPUT A–C: The Rhythm Set’s Rhythm Tones are sent to
the selected OUTPUT A–C jacks.
INDIV 1–6: The Rhythm Set’s Rhythm Tones are sent to the
selected INDIVIDUAL 1–6 jack.
TONE: The Rhythm Tones are routed to jacks according to
their output settings.
A
B
C
CHO
REV
RHYTHM
TONE
OUTPUT A
OUTPUT B
OUTPUT C
M-FX
Output Assign (OUTPUT)
Output Assign
(RHYTHM MFX OUT)
Output Assign
(RHYTHM CHO OUT)
Output Assign
(RHYTHM REV OUT)