Roland XV-3080 - Manual (Page 12)

12
Front and Rear Panels
Rear Panel
M
AC Inlet
Connect the included power cable here. (Quick Start p. 10)
N (MIDI)
MIDI Connectors (IN, OUT, THRU)
These connectors connect the XV-3080 with other MIDI
devices, enabling the sending and receiving of MIDI
messages. (Quick Start p. 10)
IN: This connector receives messages from another MIDI
device.
Out: This connector transmits messages to a MIDI device.
Thru: MIDI messages received at the MIDI IN connector will
be retransmitted from this connector without being changed
by the XV-3080.
O (OUTPUT)
A(MIX) OUTPUT Jacks (L (MONO), R)
These jacks send audio signals in stereo (L/R) from the XV-
3080 to an amp or mixer. For a mono output, use only the L
jack. (Quick Start p. 10)
These jacks are used when the SYSTEM SETUP Mix/Parallel
parameter is set to MIX. (p. 73, p. 76, p. 79, p. 81)
* The XV-3080, as shipped from the factory, routes the output
of all PRESET Patches to these jacks.
P (OUTPUT)
B, C OUTPUT Jacks (L, R)
These jacks send audio signals in stereo (L/R) from the XV-
3080 to an amp or mixer. (Quick Start p. 10)
Q (OUTPUT)
INDIVIDUAL 1–6 OUTPUT Jacks
These jacks output audio signals in mono from the XV-3080
to an amp or mixer. (Quick Start p. 10)
M
N
Q
P O