Roland XV-3080 - Manual (Page 130)

130
Chapter 8 Other Settings and Checking
Status
Adjusting the Overall Tuning
of the XV-3080
Master Tune and Master Key
Shift
The Master Tune and Master Key Shift settings are common
to all Patches, Performances, Rhythm Sets, and the GM
Mode.
Master Tune
This adjusts the overall tuning of the XV-3080. The setting is
expressed as the frequency played by the A4 key.
KeyShift (Master Key Shift)
This shifts the overall pitch of the XV-3080 in semitone steps.
1. Press [SYSTEM] to make its indicator light.
2. Press the [TUNE] function select button (displayed in
gray) to make its button indicator light.
3. Use [ ]/[ ] to select the SYSTEM TUNE page.
4. Press [ ]/[ ] to move the cursor to the number
underneath the item you wish to set.
5. Turn the VALUE dial or press [INC] / [DEC] to select the
desired value.
* If making a mistake requires you to press [UNDO], the
current parameter’s value will return to the setting that was
in effect when the cursor was first moved to the parameter.
Press [UNDO] again to restore the new setting value.
6. Press [EXIT] to return to the previous page.
Scale Tune
The XV-3080 allows you to use temperaments other than
equal temperament. The pitch of each note can be adjusted in
1-cent steps (1/100th of a semitone) relative to its equal-
tempered pitch.
One set of Scale Tune settings can be created in Patch mode.
In Performance mode and GM system mode, each Part can
have its own Scale Tune settings.
* The selected scale applies to MIDI messages received from an
external MIDI device as well as to local sound generation.
Scale Tune (Scale Tune Switch)
Turn this on when you wish to use a tuning scale other than
equal temperament.
● The settings in Patch mode (PATCH SCALE)
1. Press [PATCH] to make its indicator light.
2. Press [SYSTEM] to make its indicator light.
3. Press the [TUNE] function select button to make its
indicator light.
4. Use [ ]/[ ] to select the SYSTEM TUNE page.
5. Use [ ]/[ ] to move the cursor to “Scale Tune.”
6. Press [Inc] to turn the parameter on.
7. Use [ ]/[ ] to select the PATCH SCALE page.
8. Press [ ]/[ ] to move the cursor to the number
underneath the note you wish to re-tune.
9. Use the VALUE dial or [INC] / [DEC] to select the
desired value.
* If you made a mistake in setting the parameter value, press
[UNDO] to restore the parameter to its original value.
10. Press [EXIT] to return to the PATCH PLAY page.
● The Setting In Performance mode/GM mode (KEY
SCALE)
1. Press [PERFORM] or [GM] to make its indicator light.
2. Press [SYSTEM] to make its indicator light.
3. Press the [TUNE] function select button to make its
indicator light.
4. Use [ ]/[ ] to select the SYSTEM TUNE page.
5. Use [ ]/[ ] to move the cursor to “Scale Tune.”
6. Press [Inc] to turn the parameter on.
7. Use [ ]/[ ] to select the KEY SCALE page
corresponding to the note you wish to set.
8. Use [ ]/[ ] to select the Part for which you wish
to make settings.
9. Use the VALUE dial or [INC] / [DEC] to select the
desired value.
* If you make a mistake in setting the parameter value, you can
press [UNDO] to restore the parameter to its original value.