Nortel Networks 2500 Series - Manual (Page 74)

74 NNCLI quick reference
Configure Secure Shell (SSH)
Perform these commands to configure SSH.
Command Purpose
ssh pass-auth Enable password authentication for SSH.
To use SSHv2 for switch access, ensure that
you use SecureCRT 4.1 or higher, Putty, or
Linux SSH.
ssh Enable SSH support.
show ssh global Display SSH settings.
Configure Telnet
You can disable Telnet access to, for example, secure the switch from
remote access.
To disable Telnet access, enter telnet-access disable .
Configure Simple Network Time Protocol (SNTP)
Perform these commands to configure SNTP.
Command Purpose
sntp server primary address
address>
Set SNTP server address where
is the address of the SNTP server in decimal
notation.
sntp enable Enable SNTP.
show sntp Display SNTP settings SNTP.
The SNTP default setting is Greenwich Mean
Time (GMT).
Configure log settings
Perform these commands to configure log settings.
Command Purpose
logging volatile overwrite Allow log to roll over if buffer is full.
logging remote address
IP>
Set syslog server.
logging remote level informational Log all events.
logging remote enable Enable syslogging.
Configure Secure Socket Layer (SSL)
Perform these commands to configure SSL.
Nortel Ethernet Routing Switch 2500 Series
Fundamentals
NN47215-102 01.01 Standard
27 October 2008
Copyright © 2008 Nortel Networks
.