Nortel Networks 2500 Series - Manual (Page 34)

34 User interface fundamentals
3 Click OK.
--End--
Setting properties after access
Procedure Steps
Step Action
1 To set Device manager properties after you access a device,
from the Device Manager menu bar choose Device > Properties
> Devices.
2 Select the IP address of a device from the Properties Device
List.
3 Click Edit.
4 Configure the properties in the Properties window.
5 Click OK.
--End--
Variable definitions
Area Item Description
Status Interval Interval at which statistics and status information is gathered.
For a full stack, set this interval to between 120 and 300
seconds.
Hotswap Detect
every The frequency at which Device Manager polls for hot swap
module information. This value relates to the Status Interval
value. For example, if the status Interval is set to 120, and the
value for Hotswap Detect every is 2, Device Manager polls
the hot swap modules every 240 seconds. For less hot swap
polling, set the value to poll every 2 or 3 intervals.
Polling
Enable Enables (true) or disables (false) periodic polling of the device
for updated status. If polling is disabled, the chassis status is
updated only after you choose Device > Refresh Status.
Nortel Ethernet Routing Switch 2500 Series
Fundamentals
NN47215-102 01.01 Standard
27 October 2008
Copyright © 2008 Nortel Networks
.