Nortel Networks 2500 Series - Manual (Page 15)

NNCLI concepts 15
Interface Configuration mode, also known as ifconfig mode, provides
commands used to configure parameters for each port or VLAN such as
speed, duplex mode, and rate limiting.
With sufficient permission, you can use the rules in the following table to
move between the command modes.
Command mode and sample
prompt Entrance commands Exit commands
User Executive
2526T> No entrance command, default
mode exit
or
logout
Privileged Executive
2526T# enable exit
or
logout
Global Configuration
2526T# From Privileged Executive
mode, enter
configure
To return to Privileged
Executive mode, enter
end
or
exit
To exit NNCLI completely,
enter
logout
Interface Configuration
2526T# From Global Configuration
mode:
To configure a port enter
interface fastethernet
To configure a VLAN enter
interface vlan
number>
To return to Global
Configuration mode, enter
exit
To return to Privileged
Executive mode, enter
end
To exit NNCLI completely,
enter
logout
NNCLI help
This section describes help available in NNCLI.
NNCLI help is available at all levels.
Command list
To determine whether a command is available from the current mode, you
can obtain a list of all commands available from the prompt.
To obtain a list of all commands available from a prompt, enter a question
mark (?).
Nortel Ethernet Routing Switch 2500 Series
Fundamentals
NN47215-102 01.01 Standard
27 October 2008
Copyright © 2008 Nortel Networks
.