Nortel Networks 2500 Series - Manual (Page 72)

72 NNCLI quick reference
Configure VLANs and tagged uplinks
Perform these commands to configure VLANs and tagged uplinks.
Command Purpose
Vlan configcontrol automatic Automatically delete old VLANs and update
PVID if a VLAN is added to an untagged port
(setting appears at the bottom of the VLAN
configuration information).
vlan ports tagging
tagall
Enable tagging on the uplink.
vlan ports filter-unta
gged-frame enable
Discard untagged frames.
vlan ports ALL filter-unregistered-fr
ame disable
Break STP for VoIP.
vlan create type port Create the port based VLAN and assign the
802.1q identifier.
vlan name Name the VLAN according to conventions.
vlan menbers add Add ports to appropriate VLANs.
vlan mgmt Set the management VLAN.
vlan members remove 1 ALL Remove all ports from VLAN 1.
vlan ports pvid Set the PVID on the uplink.
show vlan Verify VLAN configuration.
show vlan interface info Verify configuration of PVID and port type.
Configure Internet Group Management Protocol (IGMP)
Perform these commands to configure IGMP.
Command Purpose
vlan igmp snooping enable Enable IGMP snooping on each appropriate
VLAN.
vlan igmp proxy enable Enable IGMP proxy on each appropriate VLAN.
show vlan igmp Show IGMP information for each appropriate
VLAN.
Configure a port
Perform these commands to configure a port.
Command Purpose
interface fastEthernet
list>
Enter configuration mode at the interface
level where you can configure multiple ports,
excluding uplink ports, simultaneously.
Nortel Ethernet Routing Switch 2500 Series
Fundamentals
NN47215-102 01.01 Standard
27 October 2008
Copyright © 2008 Nortel Networks
.