Nortel Networks 2500 Series - Manual (Page 22)

22 User interface fundamentals
Selecting all ports in a stand-alone switch or stack
Procedure Steps
Step Action
1 To select all the ports in a stand-alone switch or in a stack, from
the Device Manager menu bar choose Edit > Select > Ports.
--End--
Selecting all switch units in a stack
Procedure Steps
Step Action
1 To select all units in a stack, from the Device Manager menu bar
choose Edit > Select > Units.
--End--
Selecting an entire stack
Procedure Steps
Step Action
1 To select an entire stack, from the Device Manager menu bar
choose Edit > Select > Chassis.
--End--
LEDs and ports
LED color in Device view mirrors the physical switch LEDs except that
LEDs in Device view do not blink.
Ports in Device view are also color coded to demonstrate port status. To
see the port color legend, from the Device Manager menu bar choose
Help > Legend.
The following table describes the port color codes.
Color Description
Green Port is operating
Red Port has been manually disabled
Orange Port has no link
Light Blue Port is in standby mode - not supported in all switch models
Dark Blue Port is being tested - not supported in all switch models
Nortel Ethernet Routing Switch 2500 Series
Fundamentals
NN47215-102 01.01 Standard
27 October 2008
Copyright © 2008 Nortel Networks
.