Nortel Networks 2500 Series - Manual (Page 71)

Configure Simple Network Management Protocol (SNMP) 71
Command Purpose
boot default Return a switch, or switches, to factory default
configuration.
restore factory-default [-y] Return a switch, or switches, to factory default
configuration where [-y] instructs the switch not
to prompt for confirmation.
Configure the management IP address
Perform these commands to configure and verify the Management IP
Address.
Command Purpose
ip address netmask Set the management IP and mask.
ip default-gateway
IP>
Set the default gateway IP address.
ping Verify connectivity.
show ip Verify configuration.
Configure Simple Network Management Protocol (SNMP)
Perform these commands to configure SNMP.
Command Purpose
snmp-server enable Enable SNMP (default is disabled).
snmp-server authentication-trap
enable
Enable authentication traps.
snmp-server community ro Set the read-only community name
(requirement: enter community string twice).
snmp-server community rw Set the read-write community name
(requirement: enter community string twice).
snmp-server contact "whatever you
want"
Set contact information.
snmp-server location "
Closet #>
Set building name and closet information.
snmp-server name "
address>"
Maintain coherent Syslog messages.
snmp-server host
y>
Set IP address of Jscan trap receiver.
show sys-info Verify configuration.
show snmp host Verify configuration.
Nortel Ethernet Routing Switch 2500 Series
Fundamentals
NN47215-102 01.01 Standard
27 October 2008
Copyright © 2008 Nortel Networks
.