NEC Express5800 Series EXP320B - Manual (Page 91)

Linux Setup and Operation 3-9
<< recovery to each md device. After a while, use the following
command and check the status again.>>>
#service diskdmp initialformat
#diskdumpctl /dev/hadb6
<<and regisrer the disk devices again.>>>
Command Action
1 New Disks
2 Remove Half Disk
3 Repair Disk
4 Remove Full Disks
5 Status(Raid)
6 Status(All Disks)
9 <= Return
Command:5
[Status(Raid)]
Name Partition Status Member
--------------------------------------------------
md1 / duplex (0)hada2 (3)hadb2
md2 duplex (0)hada3 (3)hadb3
md0 /boot duplex (0)hada1 (3)hadb1
<<< If each md device’s status is duplex, disk duplication is completed.>>>
TIPS:
„ If you attempt to start ftdiskadm more than once at a time, “Cannot start” is
displayed. If this message is displayed even when only one ftdiskadm is started, it
may have been terminated without clearing the information. In such a case, run
ftdiskcleanup and then start ftdiskadm.
„ The trace log of ftdiskadm is recorded to the /var/log/ftdiskadm directory. If the files
occupy a large part of the disk space, delete them from the oldest.
„ Boot disks are inserted into the Slot0 and Slot3 normally. If you can only boot the
system in the simplex mode, insert a boot disk into the Slot0 and boot the system.
IMPORTANT:
Never use the command that directly deletes SCSI disk for separating a SCSI disk. If
you do, RAID cannot be recovered when the deleted SCSI disk is included in the md
device.