NEC Express5800 Series EXP320B - Manual (Page 163)

System Configuration 4-65
- LAN
c
d
e
(1) The MAC address of the BMC
(2) Lets you choose whether or not to acquire an IP address automatically by DHCP.
(3) Lets you make the IP address settings if the address is not acquired automatically by DHCP.
If the address is acquired automatically by DHCP, the data acquired is shown here.
IMPORTANT:
„ Specify different IP addresses to CPU/IO module #0 and CPU/IO module #1.
„ If you change the IP address, the current connection will be disconnected when the BMC
settings are completed by clicking OK. Close the window once, and then log on again by
entering the newly set IP address (or host name) in the browser.
„ The logon page remaining on the browser is the page you accessed by using the old address.
You cannot use it to log on.
„ When you configure “default gateway,” the gateway, the server, the management PC should
be in a state where communication over network is available.
„ If you make the settings in a state where communication is not available, you need to switch
on/off the AC of the server in a state where the gateway, the server and the management PC
can be communicated over the network.