NEC Express5800 Series EXP320B User Manual
Page 118
4-20 System Configuration
Server
Move the cursor onto [Server] to display the Server menu.
The following describes options you can configure in the Server menu and their functions.
Select an option with the "
Ź" mark and press Enter to display its submenu.
Refer to the table below for information on options.
Option
Parameter
Description
Thermal
Sensor
[Disabled]
Enabled
Enable or disable the thermal sensor
functions.
BMC IRQ
Disabled
[IRQ 11]
Set the IRQ of BMC interruption.
Post Error
Pause
[Disabled]
Enabled
Set whether or not to pause POST at the end
of POST if an error has occurred during
POST execution.
AC LINK
Stay Off
[Last State]
Power On
Specify the AC LINK feature by selecting the
status of the power supply unit of the server
when the AC power supply restarts. (See the
table on the next page for details.)
Power ON
Delay Time
[0]-255
Configure the DC ON delay time if AC LINK
is set to “Power On” or “Last State” (unit:
second).
[ ]: Factory-set
* “Console Redirection” is shown only when the N8815-001/001A ft Remote Management Card is
installed.