NEC Express5800 Series EXP320B - Manual (Page 117)

System Configuration 4-19
See the table below for setup options on the screen.
Option Parameter Description
User Password
is [Clear]
Set Indicates User password setup status (view only).
Supervisor
Password is [Clear]
Set Indicates User password setup status (view only).
Set User
Password [Enter] Press Enter to display the user password entry
screen. With a user password, accessing the
SETUP menus is restricted. This option is
available only if the Supervisor Password is
specified.
Set Supervisor
Password [Enter] Press Enter to display the supervisor password
entry screen. This option is available only when
you log into the SETUP utility with the supervisor
password.
Password on
boot [Disabled]
Enabled Specify whether to request a password entry at
boot-up. User password setup is required
beforehand.
Switch Inhibit [Disabled]
Enabled Enable or disable the POWER switch on the
server. If you select to enable, the switch will be
disabled.
[ ]: Factory-set
IMPORTANT:
If you have logged in SETUP by using the Supervisor Password, you can check and change all
settings. If you have logged in SETUP by using UserPassword, you see the settings but cannot
make changes on the settings except System Time, System Date and User Password of Main.