NEC Express5800 Series EXP320B - Manual (Page 291)

Troubleshooting 7-19
Message Meaning Action
The driver started to set the
MTBF threshold. The driver started setting the
MTBF threshold.
The driver finished successfully
to set the MTBF threshold. The driver successfully set the
MTBF threshold.
The driver started to set the
MTBF type. The driver started setting the
MTBF type.
The driver finished successfully
to set the MTBF type. The driver successfully set the
MTBF type.
The server is operating
normally.
Board bootup error log detected
in the Module. An error log at the module
startup was detected. There may be problem in
the system environment.
Contact your sales agent.
[FT LED: Amber Blink] It is
dumping it. [FT LED: Amber Blink] Collecting
dump. The server is operating
normally.
[FT LED: Amber On] MTBF of
the CPU module is below the
threshold. [FT LED: Amber On] The MTBF
of the CPU module is lower than
the threshold.
[FT LED: Amber On] MTBF of
the IO module is below the
threshold. [FT LED: Amber On] The MTBF
of the IO module is lower than
the threshold.
If the message is recorded
frequently, there may be
problem in the system
environment. Contact your
sales agent.
[FT LED: Amber On] Module
broke down. [FT LED: Amber On] The module
failed.
[FT LED: Amber On] Not able to
bind PCI Express 0. It has
broken down in the past. [FT LED: Amber On] The PCI
Express 0 cannot be bound
because it has failed in the past.
[FT LED: Amber On] Not able to
bind PCI Express 1. It has
broken down in the past. [FT LED: Amber On] The PCI
express 1 cannot be bound
because it has failed in the past.
[FT LED: Amber On] Not able to
bind South Bridge. It has
broken down in the past. [FT LED: Amber On] The South
Bridge cannot be bound because
it has failed in the past.
[FT LED: Amber On] Not able to
bind Module. It has broken
down in the past. [FT LED: Amber On] The module
cannot be bound because it has
failed in the past.
There may be problem in
the system environment.
Contact your sales agent.
[FT LED: Green On] The
system was duplex. [FT LED: Green On] The system
was duplexed. The server is operating
normally.
[FT LED: Off] The driver did not
bind the CPU module. [FT LED: Off] The CPU module is
not bound.
[FT LED: Off] The driver did not
bind the IO module. [FT LED: Off] The IO module is
not bound.
[FT LED: Off] The Network
device is not duplex. [FT LED: Off] The network device
is not duplexed.
[FT LED: Off] The SCSI device
is not duplex. [FT LED: Off] The SCSI device is
not duplexed.
Take necessary actions
referring to
“Troubleshooting” in the
User’s Guide.