NEC Express5800 Series EXP320B - Manual (Page 253)

Installing and Using Utilities 5-69
Settings can be made in the [System Configuration] window of Server Maintenance Utility.
The table below shows the potential cases in which the system operation setup is changed. Contact
your maintenance personnel for the change of the system operation setup. Setting change will take
effect after system reboot. However, the utility does not indicate that reboot is required.
The system operation settings cannot be made while collecting dump or updating firmware. Wait until
such processing is finished to make the settings.
Quick dump
Automatic firmware
update
Automatic module start
Component
Remote Local Remote Local Remote Local
Whole
system – Executable if
the system is
operating.
When dump is
acquired by
using the
dump function
normally
installed in OS
at occurrence
of system
fault.
– Executable if the
system is
operating.
When firmware is
updated manually
at insertion of
new module
– Executable if the
system is
operating.
When firmware is
started manually at
insertion of new
module
Remote: Executable from remote management PC by using NEC ESMPRO Manager
Local: Executable on local server by using Server Maintenance Utility
–: Not support
Configure the system settings using the Server Maintenance Utility in the following procedure. The
system cannot be configured using the NEC ESMPRO Manager.
1. Select [System Setting] on main window of the Server Maintenance Utility. The [System
Setting] screen is displayed.
2. Change the properties on the [System Setting] screen.
3. Select [Apply].
Sample screen of Server Maintenance Utility
[System Setting] screen
Main window