4 the control register, i2ccon (a1=1, a0=1), Pca9665 – NXP Semiconductors PCA9665 User Manual

Page 9

PCA9665_2

Product data sheet

Rev. 02 — 7 December 2006

9 of 91

NXP Semiconductors

PCA9665

Fm+ parallel bus to I

C-bus controller

In Byte mode, the CPU can read or write a single byte at a time. In Buffered mode, the
CPU can read or write up to 68 bytes at a time. See

Section 8.1 “Configuration modes”

for

more detail.

Remark: The I2CDAT register will capture the serial address as data when addressed via
the serial bus.

Remark: In Byte mode only, the data register will capture data from the serial bus during
38h (arbitration lost in slave address + R/W or data bytes causing this data in I2CDAT to
be changed), so the I2CDAT register will need to be reloaded when the bus becomes free.

In Buffered mode, the data is not written in the data register when arbitration is lost, which
keeps the buffer intact.

7.3.1.4

The Control register, I2CCON (A1 = 1, A0 = 1)

I2CCON is an 8-bit read/write register. Two bits are affected by the bus controller
hardware: the SI bit is set when a serial interrupt is requested, and the STO bit is cleared
when a STOP condition is present on the I

C-bus. A Write to the I2CCON register via the

parallel interface automatically clears the SI bit, which causes the Serial Interrupt line to
be de-asserted and the next clock pulse on the SCL line to be generated.

Remark: Since none of the registers should be written to via the parallel interface once
the Serial Interrupt line has been de-asserted, all the other registers that need to be
modified should be written to before the content of the I2CCON register is modified.

Table 9.

I2CDAT - Data register (A1 = 0, A0 = 1) bit allocation

SD7

SD6

SD5

SD4

SD3

SD2

SD1

SD0

Table 10.

I2CDAT - Data register (A1 = 0, A0 = 1) bit description

Bit

Symbol

Description

7:0

SD[7:0]

Eight bits to be transmitted or just received. A logic 1 in I2CDAT corresponds to
a HIGH level on the I

C-bus. A logic 0 corresponds to a LOW level on the bus.

Table 11.

I2CCON - Control register (A1 = 1, A0 = 1) bit allocation

ENSIO

STA

STO

MODE