Proxim ORiNOCO AP-2500 - Manual (Page 204)

204
Using the Command Line Interface
Configure Management Ports
[Device Name]>set snmpifbitmask <0, 1, 4, 8, 15
(see below)>
[Device Name]>set httpifbitmask <0, 1, 4, 8, 15 (see below)>
[Device Name]>set telifbitmask <0, 1, 4, 8, 15
(see below)>
Choose from the following values:
Edit IP Access Table
[Device Name]>set mgmtipaccesstbl ipaddr ipmask
Configure Serial Port Interface
[Device Name]>set serbaudrate <2400, 4800, 9600, 19200, 38400, 57600>
[Device Name]>set serflowctrl
[Device Name]>show serial
Figure A-14 Result of “show serial” CLI Command
NOTE
To avoid unexpected performance of your AP-2500, leave the setting Flow Control to its default value (none)
unless you are sure what this setting should be.
Interface bitmask Description
0 = disable (all interfaces) All management channels disabled
1 = ethernet if Ethernet only enabled
4 = pcCardA if Wireless A only enabled
8 = pcCardB if Wireless B only enabled
15 = allInterfaces All management channels enabled