Proxim ORiNOCO AP-2500 - Manual (Page 179)

179
Troubleshooting
4. Open your terminal emulation program (like HyperTerminal) and set the following connection properties:
• Com Port:
• Baud rate: 9600
• Data Bits: 8
• Stop bits: 1
• Flow Control: None
• Parity: None
5. Under File -> Properties -> Settings -> ASCII Setup, enable the Send line ends with line feeds option.
Result: HyperTerminal sends a line return at the end of each line of code.
6. Press the RESET button on the AP.
Result: The terminal display shows Power On Self Tests (POST) activity. After approximately 30 seconds, a
message indicates: Sending Traps to SNMP manager periodically. After this message appears, press the
ENTER key repeatedly until the following prompt appears:
[Device name]>
7. Enter only the following statements:
[Device name]> set ipaddrtype static
[Device name]> set ipaddr
[Device name]> set ipsubmask
[Device name]> set tftpipaddr
[Device name]> set tftpfilename
[Device name]> set ipgw
[Device name]> show ip (to confirm your new settings)
[Device name]> show tftp (to confirm your new settings)
[Device name]> reboot 0
Example:
[Device name]> set ipaddrtype static
[Device name]> set ipaddr 10.0.0.12
[Device name]> set ipsubmask 255.255.255.0
[Device name]> set tftpipaddr 10.0.0.20
[Device name]> set tftpfilename MyImage.bin
[Device name]> set ipgw 10.0.0.30
[Device name]> show ip
[Device name]> show tftp
[Device name]> reboot 0
Result: The AP will reboot and then download the image file. You should see downloading activity begin after a few
seconds within the TFTP server’s status screen.
8. When the download process is complete, reset the AP to factory defaults (see Reset to Factory Default Procedure )
and configure the AP settings or download configuration files to the AP that you saved as a back-up previously.