Proxim ORiNOCO AP-2500 - Manual (Page 188)

188
Using the Command Line Interface
? (List Commands)
This command has varied uses to display commands and parameters, depending on the operation in which it is used.
The following table lists each operation and provides a basic example. Following the table are detailed examples and
display results for each operation.
Example 1. Display Command list
To display the Command List, enter "?"
[Device Name]>?
Figure A-2 Result of “?” CLI command
Example 2. Display specific Commands
To show all commands that start with specified letters, enter one or more letters, then "?" with no space between letters
and "?".
[Device Name]>s?
Figure A-3 Result of “s?” CLI command
Example 3. Display parameters for set and show
Example 3a allows you to see every possible parameter for the set (or show) commands. Notice from example 3a that
the list is very long. Example 3b shows how to display a subset of the parameters based on initial parameter letters.
Example 3a. Display every parameter that can be changed
[Device Name]>set?
Operation Basic Example
Display the Command List (Example 1) [Device Name]>?
Display commands that start with specified letters (Example 2) [Device Name]>s?
Display parameters for set and show Commands (Examples 3a and 3b) [Device Name]>set ?
[Device Name]>show ipa?
Prompt to enter successive parameters for Commands (Example 4) [Device Name]>download?