Proxim ORiNOCO AP-2500 - Manual (Page 202)

202
Using the Command Line Interface
Change your Wireless Interface Settings
Enable/Disable Interference Robustness
– 3 = wireless card in Slot A
– 4 = wireless card in Slot B
[Device Name]>set wif <3 or 4> interrobust
This feature is only available for 802.11b wireless cards.
Enable/Disable Closed System
– 3 = wireless card in Slot A
– 4 = wireless card in Slot B
[Device Name]>set wif <3 or 4> closedsys
NOTE
When disabled, a client configured with the Network Name “ANY” can connect to the AP-2500. This feature is
only available for 802.11b wireless cards.
Enable/Disable Load Balancing
– 3 = wireless card in Slot A
– 4 = wireless card in Slot B
[Device Name]>set wif <3 or 4> ldbalance
This feature is only available for 802.11b wireless cards.
Enable/Disable Medium Density Distribution
– 3 = wireless card in Slot A
– 4 = wireless card in Slot B
[Device Name]>set wif <3 or 4> meddendistrib
This feature is only available for 802.11b wireless cards.
Autochannel Select (ACS)
ACS is enabled by default. In order to disable ACS, disable the cards in slots A and B and reboot.
–
3 = wireless card in Slot A
– 4 = wireless card in Slot B
[Device Name]>set wif <3 or 4> autochannel disable
[Device Name]>reboot 0
Re-enable ACS
– 3 = wireless card in Slot A
– 4 = wireless card in Slot B
[Device Name]>set wif <3 or 4> autochannel enable
[Device Name]>reboot 0
Set the Distance Between APs
– 3 = wireless card in Slot A
– 4 = wireless card in Slot B
[Device Name]>set distaps
[Device Name]>reboot 0
This feature is only available for 802.11b wireless cards.