Configuring objects that require reboot, Set” cli command, Show” cli command – Proxim ORiNOCO AP-2500 User Manual

Page 197

background image

197

Using the Command Line Interface

Configuring Objects that Require Reboot

Certain objects supported by the AP require the device to be rebooted in order for the changes to take effect. In order
to inform the end-user of this behavior, the CLI shall provide informational messages when the user has configured an
object or object(s) that requires the device to be rebooted. The following message shall be displayed as a result of the
configuring such object or objects.

Example 1: Configuring objects that require the device to be rebooted

The following message is displayed every time the user has configured an object that requires the device to be
rebooted.

[Device Name]>set ipaddr 135.114.73.10

In order for this change to take effect, the device is required to be rebooted.

Example 2: Executing the exit, quit, or done commands when an object that requires
reboot has been configured

In addition to the above informational message, the CLI also provides a message as a result of the exit, quit, or done
command if changes have been made to objects that require reboot. If you make changes to objects that require
reboot and execute the exit command the following message is displayed:

[Device Name]>exit

OR quit OR done

Modifications have been made to parameters that require the device to be rebooted. These changes will only take
effect after the next reboot.

“set” CLI Command

Sets (modifies) the value of given parameter. To see a definition and syntax example, type only set and then press the
Enter key. To see a list of available parameters, enter a space, then a question mark (?) after set (example: set?).

Syntax:
[Device Name]>set

[Device Name]>set ...
Example:
[Device Name]>set sysloc “Main Lobby”

[Device Name]>set mgmtipaccesstbl 0 ipaddr 10.0.0.10 ipmask 255.255.0.0

“show” CLI Command

Displays the value of specified parameter, or displays all parameter values of a specified group (parameter table).
Groups contain Parameters and Tables. Tables contain parameters for a series of similar entities.
To see a definition and syntax example, type only show and then press the Enter key. To see a list of available
parameters, enter a question mark (?) after show (example: show ?).

Syntax:
[Device Name]>show

[Device Name]>show

[Device Name]>show


Examples:
[Device Name]>show ipaddr

[Device Name]>show network

[Device Name]>show mgmtipaccesstbl

See also other documents in the category Proxim Hardware: