Pitney Bowes J640 - Manual (Page 95)

Example {I,B,0,0,1,10
p
}
This record would
✦ identify the supply setup record.
✦ indicate black mark stock has been loaded.
✦ indicate thermal direct supply has been loaded.
✦ cause the printer to operate in on-demand mode.
✦ feed the supply approximately 2 inch at a time before
printing the format on each label (10/192 inches).
n
The I parameter is only needed if you send these records
separately. (If you are sending multiple records, the I
parameter is only needed once.) You must resend the format
to the printer before the feed mode change takes effect.
Record C: Print Control
Use the Print Control record to set
✦ contrast adjustment
✦ vertical adjustment
✦ horizontal adjustment
✦ print speed
✦ supply width.
Use the following syntax for a Print Control record:
Syntax {I,C,contrast,print_adjust,margin_adjust,
speed_adjust,width_adjust
p
}
Co
nf
igu
ring
t
h
e P
rin
te
r
Chapter 5. Configuring the Printer
5-9