Pitney Bowes J640 - Manual (Page 225)

Error
Code Description
758 Check Supply. Either the on-demand sensor is
broken, the supply is not seen, or you have a
continuous unit set to on-demand mode. Adjust the
on-demand sensor so it is over a white area on the
supply, or set the unit to continuous mode. This
message may also appear on printer models that do
not have the rewind capability.
759 Knife is not moving. Valid only on printers with a
knife.
760 Knife jam. Valid only on printers with a knife.
761 Stacker is full. Valid only on printers with a stacker.
762 Low battery. Recharge your battery. If the error
persists, call Pitney Bowes Service.
763 Waiting to dispense label. Press the trigger. If the
error persists, call Pitney Bowes Service.
764 Verifier failed. Valid only on printers with a verifier.
765 Printhead Failure. Call Pitney Bowes Service.
J640 Programmer’s Manual
11-20