Lanier AP2610 - Manual (Page 96)

Troubleshooting
88
5
F Close the cover of the Duplex
Unit.
If the error message appears
again, go to step
B .
BBBB
Pull the Duplex Unit out of the
printer until it stops, and remove
the misfed paper.
A Push down the lever on the
right side of the Duplex Unit
(
A A A A) and pull it out until it stops
(
B B B B).
B Lift the guide board inside the
Duplex Unit, and remove the
misfed paper.
Important
❒ When A5L paper misfeeds,
you might not be able to re-
move it by pulling the Du-
plex Unit out. In this case,
pull the paper tray out and
remove the paper.
C While aligning the power cord
with the groove of the left slide
of the Duplex Unit, insert the
Duplex Unit into back of the
printer aligning the rails inside
of the printer until it is con-
nected.
If the error message appears
again, the misfed paper might
be left in the printer. Confirm
that any torn paper scraps are
not in the inside of the printer.
For more information, see p.83
“When "Remove Misfeed Inter-
nal Path/Open Front Cover"
Appears”.
ZGDY360J
ZGDX320J
ZGDY440J
ZGDX240J