Lanier AP2610 - Manual (Page 76)

Troubleshooting
68
5
Replace
Toner Cartridge
The toner cartridge is not set
correctly or toner is almost
run out. Set the toner cartridge correct-
ly. See p.90 “Replacing the
Toner Cartridge”.
The toner dust is full. Prepare a new toner cartridge.
If the image density gets too
light, replace the toner car-
tridge with a new one. See
p.90 “Replacing the Toner
Cartridge”.
Reset Fusing
Unit Correctly The fusing unit is not set cor-
rectly. Set the fusing unit correctly,
or set the proper fusing unit.
Reset Toner
Cartridge
The toner cartridge is not set
correctly. Set the toner cartridge correct-
ly. See p.90 “Replacing the
Toner Cartridge”.
The toner cartridge is not set
installed. If the cartridge is installed,
close the front cover and turn
the off power switch and then
on. If the message appears
again, contact your sales or
service representative.
Reset Tray #
Correctly
The input paper tray is not set
correctly. Set the input paper tray cor-
rectly.
Resetting Job... The print job is being reset. Wait for a while.
SC XXX-X
Power Off On
If Error Reoccur
Call Service
An error has occurred. First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
SC2001 An error has occurred in the
resident font RAM. First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
Toner Is Almost
Empty
The toner is almost run out. Prepare a new toner cartridge.
If the image density gets too
light, replace the toner car-
tridge with a new one. See
p.90 “Replacing the Toner
Cartridge”.
Waiting... The printer is waiting for the
next print job. Wait for a while.
Warming Up... The printer is warming up or
toner is being supplied. Wait until the panel display
change the "Ready".
Messages/Second messages Description Solution