Lanier AP2610 - Manual (Page 102)

Troubleshooting
94
5
Cleaning the Paper Feed
Roller
If the paper feed roller is dirty, a mis-
feed might occur. In this case, clean
the roller as follows:
R CAUTION:
Important
❒ The following are examples of
cleaning the paper feed roller on
the paper tray.
❒ You can clean the paper feed roller
on the optional Paper Feed Unit by
following the procedures below.
The paper feed roller on the op-
tional Paper Feed Unit differs from
the one on the paper tray. Confirm
the type of paper feed roller you
are installing.
AAAA
Turn off the power switch.
BBBB
Pull out the plug from the socket.
Remove all the cables from the
printer.
CCCC
Lift the paper tray slightly then
pull it out until it stops, and while
lifting the front side of the tray,
pull it out of the printer.
DDDD
Move the printer to the edge of a
stable table or desk.
Important
❒ Do not put the printer on an un-
stable or tilted surface.
❒ If the printer is equipped with
the optional Paper Feed Unit,
do not move the printer and
unit together as they are not se-
curely attached.
❒ When lifting the printer, con-
firm that the optional Paper
Feed Unit is not attached to the
printer.
• When lifting the printer, use the
grips on both sides of the printer,
otherwise the printer might fall
and cause personal injury.
• When you move the printer, un-
plug the power cord from the wall
outlet to avoid a fire or an electric
shock.
• When you pull out the plug from
the socket, grip the plug to avoid
damaging the cord and causing
a fire or an electric shock.
ZCEM200E
For the paper tray For the Paper Feed Unit
ZCEY140J
ZGDM110J