Lanier AP2610 - Manual (Page 77)

Error & Status Messages on the Control Panel
69
5
Getting Printer Information over the Network
Printer current status
You can check the printer's status using the telnet command.
❖ ❖ ❖ ❖ telnet
Use the status command.
❖ ❖ ❖ ❖ UNIX
Use the lpq or lpstat command or stat parameter of rsh, rcp, or ftp.
Reference
For more information, see “Remote Maintenance by Telnet (mshell)” in the
Network Printing Guide is provided on the CD-ROM labeled “Operating
Instructions”.
Messages Description Comments
Call Service Center There is a malfunction in the
printer. Turn the printer off and on.
Cover Open: Duplex Unit The cover of the optional Du-
plex Unit is open. Close the cover of the optional
Duplex Unit.
Cover Open: Front Cover Close the front cover. Close the front cover.
Cover Open: Mailbox The cover of the Mailbox is
open. Close the cover of the Mailbox
cover.
Cover Open: Paper Exit/Rear The paper exit cover or the
rear cover is open. Close the paper exit cover or
the rear cover.
Cover Open: Upper Tray The upper tray cover is open. Close the upper tray cover.
Empty: Toner The toner cartridge is empty. Replace the new toner car-
tridge.
Energy Saver Mode The printer is in Energy Save
Mode. Wait for a while.
Energy Saver Mode 1
Error: HDD Board An error has occurred in the
optional Hard Disk Drive. First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
IEEE 802.11b Card Error The optional IEEE 802.11b
board or the optional IEEE
802.11b card is not installed. Install the optional IEEE
802.11b board or the optional
IEEE 802.11b card.
IEEE 802.11b Card or Board
Error An error has occurred in the
optional IEEE 802.11b board
or the optional IEEE 802.11b
card First, turn the power switch
off and then on. If the message
appears again, set the optional
IEEE 802.11b board. If the
message still appears, call
your sales or service repre-
sentative.