Tuner configuration – Kathrein UFS 922 si User Manual
Page 148
148
Select Satellites
Select the “Select Satellites” field. Select here which
satellites you want to receive via your turntable. Pressing
the
button presents a display of the satellites stored
in the receiver:
Use the
buttons to select the satellites to be
received and confirm your selection in each case using
the
button. The selected satellites will be identified
with a tick.
When you have completed all settings, press the
button.
Set Up Satellites
Select “Set up satellites” field and press the
button
to allow you to make the settings/selection for the
satellite(s). The following display appears:
LNB Setting:
Select the “LNB Setting” field. If your reception system
does not have a Universal LNB, press the
button so
that you can make the settings for the LNB.
You can choose from the following LNB types:
- Universal
- Simple
- User-defined
If you select “Universal” you need make no further settings. If you select “Simple” you need to input the low
frequency manually. For this, refer to the documentation for your LNB.
If you select “User-defined” you need to manually set all the frequency ranges that are configured for your LNB.
For this, refer to the documentation for your LNB.
Satellite and position:
Select the “Satellite and Position” field. From the previously selected satellites, select here the satellite for which you
want to select a test transponder.
Test-Transponder:
Select the “Test Transponder” field and set a test transponder for the currently selected satellite. You can see from the
signal strength and signal quality when the turntable has found the desired satellite.
If you previously selected more than one satellite under “Select Satellites”, you must now make these settings for
the other satellites. Switch to the “Satellite and Position” field and select the next satellite. If necessary, repeat the
setting of the LNB. It is not essential to set a test transponder.
When all settings have been made, press the
button to exit the menu.
Tuner Configuration