Tuner configuration – Kathrein UFS 922 si User Manual
Page 145
145
Select Satellites
Select the “Select Satellites” field. Select here which
satellites you want to receive via your turntable. Pressing
the
button presents a display of the satellites stored
in the receiver:
Use the
buttons to select the satellites to be
received and confirm your selection in each case using
the
button. The selected satellites will be identified
with a tick.
When you have completed all settings, press the
button.
Set Up Satellites
Select the “Set up satellites” field. Press the
button to
allow settings/selection of the satellite(s).
The following display appears:
LNB Setting:
If your reception system does not have a Universal LNB,
press the
button so that you can make the settings
for the LNB.
You can choose from the following LNB types:
- Universal
- Simple
- User-defined
If you select “Universal” you need make no further settings. If you select “Simple” you need to input the low
frequency manually. For this, refer to the documentation for your LNB.
If you select “User-defined” you need to manually set all the frequency ranges that are configured for your LNB.
For this, refer to the documentation for your LNB.
Satellite and position:
Select the “Satellite and Position” field. From the previously selected satellites, select here the satellite for which you
want the turntable to search.
Test-Transponder:
Select the “Test Transponder” field. Select here a test transponder for the satellite being searched for, at which you
will be able to detect in the course of the search for the satellite when you have received a signal from the satellite
being searched for.
Tuner Configuration