Kathrein UFS 922 si - Manual (Page 146)

146
Stop on Signal:
Select the “Stop on Signal” field. Here, you can select whether the motorized antenna should stop its rotary
movement immediately on reception of a signal from the desired satellite. You can choose between “On” and “Off”.
Move Motorized Antenna:
Select the “Move Motorized Antenna” field. Here you can control the movements of the motorized antenna, using the
following buttons:

Start slow rotation to the West

Rotate to the West step by step

Stop the current movement

Rotate to the East step by step

Start slow rotation to the East
Set the turntable so that both of the bars “Signal-Strength” and “Signal-Quality” on the right of the screen show the highest
available percentage values.
Once you have achieved the best reception signal, select the “Store actual Position” field.
Store actual Position:
Once you have achieved the maximum signal strength and signal quality you can save the current position of the turntable
for the above mentioned satellite using the

button.
If you previously selected more than one satellite under “Select Satellites”, you must now make this setting for the other
satellites. Switch to the “Satellite and Position” field and select the next satellite. Repeat the set-up of the turntable
for this satellite, as described above.
Once you have saved the positions of the turntable for all the selected satellites, press the

button to exit the menu.
Tuner Configuration