Kathrein UFS 922 si - Manual (Page 101)

101
Network Search
Use the

buttons (On/Off) to select whether a network search should be performed. If you set the network
search to “Off”, only the factory default transponders for the satellite(s) you previously selected will be searched
for new as yet unsaved channels. If you set the network search to “On”, the transponder network enables additional
transponders that have not yet been stored to be located. They are then stored and searched for new channels in the
same way as the existing transponders. Once you have made all the settings, use the

buttons to switch to the
“Start search” field and confirm the start of the search using the

button. The following displays appear (example):
During the search you will see the following display
(example):
The new channels found are identified by the suffix
“New” (see example screenshot on the right).
TV channels
found Radio channels
found
After completion of the search, you will see the following
display (example):
Press the

button. The new channels found are added
at the end of the existing complete list.
Press the

button to return to the TV picture. The new channels can now be selected in the channel list.
Note:
You can cancel the search at any time by pressing the

button.
Main menu - Channel search