KVH Industries TracVision G8 User Manual
Page 51
Installation
54-0198
49
1. Type
HALT
to put the antenna in Idle mode.
2. Enter the
SATINSTALL
parser command as follows:
Command:
SATINSTALL,
Where:
Satellite A (for example: USER1)
Satellite B (for example: USER2)
If you only want to install and track one satellite, enter
NONE
as the name of Satellite B.
3. Once you’ve assigned satellites as Satellite A and Satellite
B, you need to tell the antenna which of the two satellites
it should initially acquire and track. This step should be
performed the first time a satellite is selected, allowing
the system to download the channel guide. To do so, enter
the following parser command:
Command:
@L,A or B
Where:
A = track Satellite A
B = track Satellite B
4. Type
ZAP
to restart the antenna.
Examples of the user-defined satellite configuration process are
provided for reference in the next two sections.
European systems only:
If DiSEqC is active on your
receiver, once the antenna restarts,
the antenna starts tracking the
satellite currently selected by the
receiver, overriding the @L
command.