KVH Industries TracVision G8 - Manual (Page 25)

Table 2-3 Kitpack Contents (continued)
Part Part # Qty.
#6 flat washers 14-0024 2
Small Ferrite Coil 29-0088 1
Large Ferrite Coil 29-0090 1
F-type connector 23-0213 1
Choosing Component Locations
When choosing component locations, first keep in mind
accessibility and cable lengths between units. For example, since
the data/power cable is 100 ft (30 m) long, the MCU must be
located within 100 ft (30 m) of the antenna. The major
considerations in locating system components are noted below.
Choosing the Best Location for the TracVision Antenna
There are several factors to consider when choosing the location
for the TracVision antenna.
• Since the TracVision antenna requires a clear view of the
sky to receive satellite signals, the ideal antenna site has
an unobstructed view of the horizon/satellite all around.
The less blockage, the better the system performs.
• Keep the antenna clear of any obstructions above decks.
The antenna requires a -15º to +85º look angle to receive
satellite signals.
Figure 2-1 Antenna Blockage
Installation
54-0198 23
Blocked!
TracVision Antenna
Vessel Platform
Mast