beautypg.com

4 - wiring the mcu, 4 wiring the mcu, Connecting the antenna data/power cable – KVH Industries TracVision G8 User Manual

Page 37

background image

2.4

Wiring the MCU

All other wiring for the TracVision system connects at the rear
panel of the MCU.

For the TracVision system to work properly, you must connect
the following cables to the MCU:

Antenna data/power cable

Vessel power cable

Figure 2-16 shows the MCU’s rear panel connectors. Refer to this
figure when wiring components to the MCU.

Figure 2-16

MCU Rear Panel

Connecting the Antenna Data/Power Cable

Connect the antenna data/power cable to the data/power
connector on the MCU’s rear panel (see Figure 2-16). Do not
overtighten; finger-tight is sufficient.

Installation

54-0198

35

Antenna

Data/Power

Vessel Power

+ -

Maintenance Port

(for PC diagnostics)

RF PCB Software Flashing Port
(technician’s use only)

Fuse

MCU Ground Wire