KVH Industries TracVision G8 - Manual (Page 108)

5.14 Replacing the Elevation Belt
1. Loosen (do not remove) the four #8-32 screws securing
the motor to the antenna frame until the motor is free to
slide upward. Raise the motor to the top of the slots and
retighten the screws to hold it in place.
Figure 5-24 Elevation Belt
2. Roll the belt over the motor hub, then over the elevation
pulley. Discard the old belt.
3. Carefully work the new belt around the elevation pulley,
between the rollers, and around the motor hub. Ensure
that the teeth are on the inside of the belt. Once the belt is
in place, work it back and forth to ensure that the belt is
aligned and the teeth are engaged with the pulley.
4. Loosen the #8-32 screws and slide the motor downward
until the belt is tight around the motor hub and the
elevation pulley. Some readjustment may be necessary if the
belt tension results in excessive vibration.
5. Tighten the motor screws.
54-0198 112
TracVision G8 Owner’s Manual - Guide to Technical Information
Elevation Belt
Elevation Pulley
Reflector
Rollers
Motor Hub
#8-32
Screws and
Washers
(x 4)