Sharp AR-M257 - Manual (Page 155)

25
HOW TO USE THE NETWORK SCANNER FUNCTION
2
SCANNING A LARGE NUMBER OF ORIGINALS (when
an RSPF is installed)
If you have a large number of originals, the originals can be scanned in batches using the RSPF.
1 Make sure the machine is in scanner
mode and then load the document in
the RSPF. (p.20)
2 Touch the [ORIGINAL] key.
3 Touch the [JOB BUILD] key.
If you wish to rotate the
original 90° when creating
an image file, touch the
[ROTATE THE IMAGE 90
DEGREES] checkbox (a
checkmark should appear
in the box).
4 Touch the [OK] key.
You will return to the
initial screen.
A job build icon appears next to the [ORIGINAL] key.
5 Perform steps 4 through 9 of "BASIC
TRANSMISSION METHOD". (p.20 to 21)
6 Press the [START] key ( ).
Scanning of the originals
begins. A message
appears in the touch
panel.
7 When all of the originals in the RSPF
have been scanned, load the next
batch and press the [START] key (
).
Repeat this sequence until all pages have been
scanned.
8 When all originals have been
scanned, touch the [READ-END] key.
"SENDING. PRESS [C]
TO CANCEL." appears in
the touch panel and
transmission begins.
When transmission is
finished, "SENDING
COMPLETED." appears
in the touch panel.
If the correct original size does not appear in
the screen of step 2, touch the [MANUAL] key
and specify the correct original size (p.26).
AUTO 8½X11
ORIGINAL
300dpi
RESOLUTION
TIFF-G4
FILE FORMAT
MANUAL
ROTATE THE IMAGE 90 DEGREES
OK
2-SIDED
TABLET JOB
BUILD
RIGINAL SIZE
Note
MANUAL
ROTATE THE IMAGE 90 DEGREES
OK
2-SIDED
TABLET JOB
BUILD
NAL SIZE
300dpi
QUALITY
RESOLUTION
TIFF-G4
FILE FORMAT
AUTO 8½X11
ORIGINAL
If no action is taken for one minute, scanning
automatically ends and transmission begins. Note
READ-END
ESS [START].
EAD-END].
• Job build mode turns off after transmission is finished. Job build mode can also be canceled by pressing the
[CLEAR ALL] key ( ).
• When performing Scan to E-mail, see the notes on page 22.
Note
!Andromeda-NS_Sec.book 25 ページ ２００６年１１月２７日 月曜日 午後５時１０分