Siemens 2015 - Manual (Page 70)

Operation with several base stations
61
Gigaset 2015 plus, GBR: A30852-X-1105-B301-1-7619 kap15.fm5 29.10.99
Operation with several base stations
You can “log on” and operate your handset at up to 4 Gi-
gaset base stations of the Gigaset family (from Gigaset
1010 and Gigaset 2010 and higher).
This has the following advantages:
● You can operate the same handset at geographically
dispersed base stations (e.g. at home and in the
office).
● In large premises, a number of base stations can be
positioned to give you much wider coverage with the
same handset.
Activating/deactivating base station number display on handset
You can program your handset to display the base
station with which the unit has radio contact.
Note the following important points when oper-
ating a handset at several base stations:
● Calls in progress are interrupted or cleared
down when you switch from the radio
range of one base station to the radio range
of another base station.
● Internal calls can only be made within the
radio range of a base station - not to hand-
sets which are within radio range of a differ-
ent base station.
● If your handset is switched on and you are
out of range of all base stations for
several minutes, it can take up to 20 min-
utes to “relocate” a base station. In such
cases you can speed up the process of
relocation by switching the handset
on and off (➔ page 14).
B
3 6
Start the procedure. The current setting is displayed:
36 1 = activated, 36 0 = deactivated.
1
B Activate the base station number display.
or
0 B Deactivate the base station number display (default).