Siemens 2015 - Manual (Page 66)

Logging on additional handsets at the base station
57
Gigaset 2015 plus, GBR: A30852-X-1105-B301-1-7619 kap13.fm5 29.10.99
Logging on additional handsets at the base station
You can operate the following at a Gigaset 2015 plus
base station: up to six Gigaset
1000S/2000S or Gigaset
1000C/2000C/2000C pocket/2000T as well as the Gigas-
et 1000TAE cordless socket.
The Gigaset 2000S handset has already been logged on
with the internal telephone number 1 at the base station
with station number 1.
Each additional handset must be “logged on” at the base
station.
Logging on Gigaset 2000S/1000S handset at the base station
Prepare the base station
Log on handset
If you wish to operate your handset at several
(up to 4) base stations (➔ page 61), you must re-
peat the following procedure at each of these
base stations.
The handset must be switched off
(➔ page 15)
? Keep pressing the green paging key at the base station
until you hear the log-on (registration) tone (this takes
roughly 10 seconds).
1 or 2,3,4
Handset must be switched off. Within one minute: en-
ter and hold down station number of the base station (1)
on the handset.
h Press this key also, until the display appears on the
handset. The handset is switched on.
Examples: logging on
● Logging onto the 1st base station
hold down 1 , and press h .
Station number
● Logging onto the 2nd base station
hold down 2 , and press h .
1
f
N
o
#
Enter the 4-digit system code (default “0000”) (➔ page
19) and then enter # . All unassigned internal numbers
are shown in the display of the handset after a brief delay: