Smart Technologies SMART BOARD 4000I User Manual

Page 83

Appendix A: Disassembling and Reassembling the Cabinet

1. Replace the two hex socket screws shown below using the 5/32" hex key from the

accessory kit. (If you’ve attached the videoconferencing mounting arm, you’ve already
replaced one of these screws.)

2. Reattach the infrared (IR) receiver to the right side of the cabinet.

3. Return the J-hook and cables to the right side panel and feed the cables through the

hook.

To return the cabinet to its operating state

J-Hook

NOTE: The cables aren’t
shown in this illustration.