Smart Technologies SMART BOARD 4000I - Manual (Page 21)

Setting Up the 4000i 11
1. Choose the side on which you want to mount the shelf. Also select which of the three
height options you want to use.
2. Using the hex-head screwdriver that comes with your videoconferencing shelf kit,
remove the three 1/4-20 x 1/2" fasteners as shown. Note that one of these fasteners is
a safety screw.
3. Remove the caps and plug from the mounting arm at the location where you want to
mount the shelf. Feed the cables for the videoconferencing camera through the large
hole, down the channel and out through the lower mounting point.
To install the videoconferencing shelf
CAUTION
Do not move the cabinet until you replace the safety screw (step 6).
Safety Screw
NOTE: The cables shown in this
illustration may not match your
videoconferencing camera.