Smart Technologies SMART BOARD 4000I - Manual (Page 24)

14 Setting Up the 4000i
Removing the Rear Access Panel
You must remove the rear access panel before you can install devices inside the cabinet, such
as the internal computer and the projector. After you install these devices, replace the rear
access panel to keep your equipment secure.
Figure 8: The Rear Access Panel
1. Loosen the two captive thumbscrews at the top of the rear access panel.
2. Tilt the top of the rear access panel toward you and then pull it upwards, releasing it
from the cabinet.
To remove the rear access panel
TIP
To return the rear access panel to the cabinet, perform these steps in reverse
order.
Rear Access Panel
Captive Thumbscrews