Smart Technologies SMART BOARD 4000I - Manual (Page 74)

64 Appendix A: Disassembling and Reassembling the Cabinet
1. Remove the two hex socket screws (shown below) using the 5/32" hex key from the
accessory kit.
2. Remove the two hex screws on the rear of the cabinet using the 5/32" hex key from
the accessory kit.
To remove the right side panel
IMPORTANT
Only remove the outside hex socket screw shown above.
Do not remove the safety screw that’s closer to the inside corner.
Do not remove this screw
Outside Hex Socket Screw
Rear Hex Screws